anti roll bar

[J$£5GTT]

going to re-fit tommorow,car on axle stands at moment,but when
i re-fit do i need the wheels to be touching the ground so suspension
is under some load?,or could i jack up the wishbones so im able to get
underneath an tighten up the bolts?,haynes mentions laden weight??
thanks
:)

[J$£5GTT]

any tips,if anyone has replaced there bushes an found the best
way to re-fit it.
:):cool:

[Alastair]

If you find it hard to get the bolts in to the clamps with your new bushes you can make them nice and soft by putting in hot water ... You might have to jack up one wishbone to get it on
Too, sure you'll be fine it's fairly straight forward mate.

[J$£5GTT]

If you find it hard to get the bolts in to the clamps with your new bushes you can make them nice and soft by putting in hot water ... You might have to jack up one wishbone to get it on
Too, sure you'll be fine it's fairly straight forward mate.


thanks
:agree::):cool:

[Shane P]

I did mine a few days ago J, not a fun job :)

[J$£5GTT]

I did mine a few days ago J, not a fun job :)

must be the salty air!!
:dearme:

[J$£5GTT]

thanks for pointers,roll bar all poly bushed an new ball joints to,
nice an tight now,was feckling about for a while,scissor jacked the
wishbones up bit of wiggling an pissin about,lots of copper slip,
an all torqued up as per haynes,but hey i done it..sweet!!!
:):cool:

[Shane P]

Nice one J, time for a 5 mission somewhere soon mate :smokin: