Oil pressure and temperature sender fitment

[tiff_lee]

I have a oil pressure and temperature gauge to fit which use remote senders and i'm not too sure where to place them.

I was thinking of running an oil line directly from the turbo behind the firewall by having a take off point from where the oil feed line goes into the turbo.
Then on the other side of the firewall another tee-piece either side of which I can fit the remote senders.

Any thoughts?

[youngscottie]

if there eletrical senders put the pressure sender into the turbo oil feed and the temp sender into the sump:coffee:

[rhys]

New poster! (less than 10 posts)

ive just plumbed a mechanical pressure gauge into my turbo oil feed, demon tweeks said i needed about different 5 bits an wud cost me 40bucks but i got one piece that did it all from http://www.thinkauto.com/ for about a tenner lol

[tiff_lee]

How you go about sump fitment, just drill and tap it?

[tiff_lee]

So has no one else fitted a oil temp sender to their sump?
Would it really be that bad taking the temperature from the turbo feed line?

[Alex]

My temp sender is on the sump. I drilled a hole in it and soldered the sender in place. :) My oil pressure is taken from the top of the turbo. ;)

[Shakes]

New poster! (less than 10 posts)

ive just plumbed a mechanical pressure gauge into my turbo oil feed, demon tweeks said i needed about different 5 bits an wud cost me 40bucks but i got one piece that did it all from http://www.thinkauto.com/ for about a tenner lol
what part was it buddy?

[gtmatt]

if you ring them up explain what you need , they will know what you want :)