Simplifying Carb Vac Pipes

[Chris Hebden]

At the min i want to reduce the metres of vac pipe work that comes off my carb top! So i can see down to the carb base and reduce that pipe work later on, then finally reduce the breather system!

I've knocked up a quick sketch of what it looks like, how do people think the best way to simplify this mess is?

Cheers Chris

[tiff_lee]

Just do the breather and vac pipes cup mode?

Good carb diagram in this thread
http://www.rtoc.org/boards/showthread.php?t=4063

[Brigsy]

Just do the cup actuator/breather mod. Take the reference for the actuator from the middle pipe on the carb.

Join the two ports on the carb elbow together or block them off.

Id bin the pipe that goes to the acc pump as it doesn't make any difference to the fuelling whether its connected or not, also leaks a lot of air.

[Markey Mark (BD)]

I'd moved the water injection and boost guage from that side on the carb top, remove the acc pump pipe too as Brigsy says, leave the carb to actuator as it is and then tidy up the rest depending what the in-car boost is set up.