Door pins?

[w35ty]

Got my doors off as fitting some different ones the old doors were dropping slightly, iv got over sized pins to use do i do this option or iv read there is a kit to convert to torx?:confused:

Or do i get or pins and drill just the body and get some sleeves to insert in then fit or pins?

What people recommend? Easiest way?

[Junglist]

Easiest way drill the hinge out and drop a larger pin in.

[Junglist]

You could put sleeves in them but they have lasted 20 odd years without

[w35ty]

Iv just gone with the larger pin way drilled both the door and the body to 8mm

[Gtturbo]

Out of interest where did you get the oversized pins from mate?

[Junglist]

Out of interest where did you get the oversized pins from mate?

I've got some here for free if you come and collect them from Ellesmere Port. Just got a pack off eBay.

[Gtturbo]

Thanks for the offer, but found them on eBay and cheap as chips :)

[J$£5GTT]

You can i have seen buy stainless door pins.

Before drilling out isnt it always a good idea to just try new pins? its the pins that wear right.

[Junglist]

I thought it was the hinge that worn out, probably a bit of both.