Crossed brake pipes

[LukeRobbo]

We want to be sure that we have not crossed the brake lines from the bias valve to the master cylinder. One fitting on the bias valve is a greater diameter than the others - which side of the master cylinder should it go to?**

Thanks, Luke

[LukeRobbo]

Does Anybody have a picture of their car underneath so we can check how the pipes run

Thanks, Luke

[Goobie]

Not the best picutre, but may be some help to you buddy. :cool:

http://i1344.photobucket.com/albums/p651/GoobieAli/imagejpg1_zps64a4c99c.jpg

[Goobie]

I "think" one of the fixing nuts is one size up? Could be wrong as been a while since I took it all off, but looking at the picture it does appear to look like larger nut size on the right? :confused:

Anyway, the line/feed in goes on the top rear as seen in the pic. :agree:

[Goobie]

Here's another one, poor picutre, but may be of use. :agree:

http://i1344.photobucket.com/albums/p651/GoobieAli/imagejpg1_zps2772a066.jpg

[B18ftMOJO5]

When fitting the lines i got off you, using too much forced i snapped the front solid pipe. Just hacksaw off a little bit of the solid pipe. Get a new union and get it re flared. Easy enough to do.

[Goobie]

When fitting the lines i got off you, using too much forced i snapped the front solid pipe. Just hacksaw off a little bit of the solid pipe. Get a new union and get it re flared. Easy enough to do.

Me or Luke? :confused: Yeah, the lines etc are a bit on the fragile side, I use special brake line ring'd spanners that have a cut out on them to slot over the line if you get what I mean. :agree:

[B18ftMOJO5]

Sorry i got them off Luke lol.

[Goobie]

Sorry i got them off Luke lol.

:laugh: :agree: Although I did sell a set to some one on here but can't remember who it was now. :scared:

:)

[LukeRobbo]

Thanks for the help

I should have used the search function :-)

http://www.rtoc.org/boards/showthread.php?t=16991&highlight=master+cylinder