1.0mm a/c jet

[KEV 5 GT]

anyone have a 1.0mm a/c jet

[Jonny5]

Just drill out a 0.9

[KEV 5 GT]

ive had a 0.9 in it and runs rich ?

[Jonny5]

ive had a 0.9 in it and runs rich ?

Its an air jet, buy opening it up slightly you are letting in more air not fuel.
More air should lean things off a touch.

All done on a very slight scale if you're going 0.9 to 1.0mm tho

[KEV 5 GT]

carb setup at present is all stock jets apart from 2nd stage drilled to 1.3mm and afrs are flat out in 4th gear are 12.9

[Jonny5]

carb setup at present is all stock jets apart from 2nd stage drilled to 1.3mm and afrs are flat out in 4th gear are 12.9

You said you tried a 0.9mm and it was too rich so id drill it out to 1.0mm try it, still too rich, do it to 1.1mm.

I wouldnt go bigger than 1.3mm on the 2nd stage tho.

Suck it an see.

[KEV 5 GT]

ok i will give that a try what the best afrs to be at ?

[Jonny5]

ok i will give that a try what the best afrs to be at ?

Everyone will tell you different mate.
High 11s low 12s @ WOT seems most accepted.

http://www.rtoc.org/boards/showthread.php?t=460