valve clearance settings and guide

[Adey aka Ewok]

dont shoot me, its been about 7 years since ive had to set clearances on a gtt, havent got the haines to hand, any one got a pic of the page out of the manual or a quick guide of the way of doing it? and the clearances? just going over a mates gtt that missfires a little especially on cold start up, carbs being rebuilt new dizzy arm and plugs, just want to rule it out. car runs loads better once warm and revs cleanly.

cheers me dears

[R5MJH]

if its got a bigger cam 20/20 is good but the standard cam is 20/25 iirc matey

i get cyl 1 rocking and adjust cyl 4 in other words the opposite

keep doing opposites until you done all 4 cycles easy

[Adey aka Ewok]

stock cam in there. just cant remember the way of doing it, fully closed on 1 then adjust another from what i remember?

[R5MJH]

stock cam in there. just cant remember the way of doing it, fully closed on 1 then adjust another from what i remember?

edit post 2 matey use rocking method its p1ss easy

[R5MJH]

cyl 1 rocking adjust cyl 4
cyl 2 rocking adjust cyl 3
cyl 3 rocking adjust cyl 2
cyl 4 rocking adjust cyl 1

is that clear enough boss

by rocking i mean inlet is coming up and exhaust starts going down on that cylinder

[Bigfoot]

Rule of 9

1 and 8
2 and 7
3 and 6
etc etc

[TNT ANDY]

Rule of 9

1 and 8
2 and 7
3 and 6
etc etc

:agree:

[Adey aka Ewok]

cool cheers, 20 on the inlet 25 on the exhaust?

[R5MJH]

cool cheers, 20 on the inlet 25 on the exhaust?

yes boss use the rocking method as it quicker you adjust inlet and exhaust at the same time mate

[Adey aka Ewok]

cheers people:agree:

[Fordy]

Take out the spark plugs to make life easier

[R5MJH]

Take out the spark plugs to make life easier

agreed:agree::agree: