Engine wiring loom questions

[VALE46]

Evening everyone, Purchased a new genuine engine wiring loom the other week and want to fit it this weekend if the weather stays dry !!

Does anyone have any good detailed pics of routing etc and the alternator wiring, I`ve laid it against the old knackered loom and there does look there is small differences.

Some detailed pictures of anyones car who`s fitted a new loom would be great.:)

[robx1r]

check my project thread i'm sure there is pictures in there of it somewhere

[ScottKinnear]

http://www.rtoc.org/boards/showthread.php?t=4793

If you haven't seen this, this helped me out a lot.

[gttjames]

mikephase1 (gtturbo spares) put up a good picture within the last year on a thread, it was a picture of the wirring loom laid out and all wires labelled if anyone else remembers where it is?

[VALE46]

Thanks for all your comments guys, I`ve been fitting loom today and came across 4 wires I need identifying please, I`ve attached pictures, I need to know which ones go to the heatsheild sensor and I presume the others go to the resistor on bulkhead??

Any help always appreciated.

[chris]

Perc fan sensor and carb base I think not 100%

[chris]

Try this it's very helpful

http://www.rtoc.org/boards/showthread.php?t=27173&highlight=Engine+loom

[bigdavec1974]

Picture 1 is for the anti perc fan sensor that sits on the heat shield
Picture 2 is for the carb base sensor
Both are part of the perc fan circuit so if ya not running one just tape em up