Replacing driveshaft CV boot

[Guybrush]

Am i going to need any specific tools to make this job easier?

Looking at getting a cone thing to help get the boots on, but not sure about the clips that hold the boot onto the shaft. It's not a jubilee clip is it, it looks like some other kind of clip. Do i need a specific tool to get these bad boys on?

[Bigfoot]

Cone is very helpful, plus washing up liquid to help it go over the cone, no need for special tools to put the clips on as far as I remember when doing some.

[Nad-5GTT]

I think the clip is called an elephant ear type clip, I got a special plier type tool for this from eBay, less than a fiver I think :scratch:

[SCHWARTZ]

Did this a few months ago pliers and wire cutters work. And a little flathead to open up the brass clip. Or pick up my two driveshafts when you get the hubs:D

[Guybrush]

Did this a few months ago pliers and wire cutters work. And a little flathead to open up the brass clip. Or pick up my two driveshafts when you get the hubs:D

wishing i made it to the surrey meet now. ;)
car failed mot today, but i should be able get it sorted to make next months meet... bring them then? :)

[SCHWARTZ]

Yeah no probs you will need to remind me nearer the time though.:D