moving my compressor housing a little

[Nad-5GTT]

I've just had my turbo rebuilt. Now this afternoon I put the actuator on then bolted the turbo on and I've noticed that the actuator arm looks pissed. I'm guessing the compressor housing isn't quite in the same position as before. So does this look normal and can I spin the housing round to straighten the actuator arm. 16564 16565

[GTphil]

The actuator arm will be fine, you can rotate the housings it's usually either some 13mm's or a large clip:agree:

[Nad-5GTT]

The actuator arm will be fine, you can rotate the housings it's usually either some 13mm's or a large clip:agree:

Ok that's good then:) would it not be benificial to turn the housing a bit? Will I damage anything if I twist it round.

[GTphil]

As long as the actuator arm doesn't end up at to much of an angle you will be fine rotating the housings:)

[Nad-5GTT]

That was an easy fix:D four bolts a little tap round and its lined up nicely. 16566