Williams F7R Turbo engine, brand new. RE-LISTED OFFERS?

[BILLY-R5GTT]

Selling my FULL Williams 2.0 16v Turbo engine, fully Rebuilt and unused (not F7P head and F7r block)

A break down of spec and what's all included in the sale

Head Spec: Fully rebuilt as new everything replaced £450

Block spec: fully rebuilt, bored out, re ligned and honed £350

fully race balanced, pistons, rods (end to end and overall), crank, flywheel, clutch £150

Compression ratio set to 8.5:1 cubic capacity measured, head, block
and pistons skimmed after trial assembly £75

Crank ground polished, new main Bearings, big end bearings, rings
and all the other bits and pieces £350

Full engine assembly after stripped and report given £325

+Vat £270

Oil pump £130

Water pump £35

Timing Belt kit £100

Helix 4 paddle a few weeks use like new £400

Turbo manifold £120

Powder coating of all engine components, inlet manifold and rocker £150

Boost gauge brand new £40

Pillar pod for 2 gauges £40

2x Jap turbo adapters (inlet and outlet) £40

I will not sell anything separate unless enough interest

Total cost £3025!

£2000 takes the lot or make me a sensible offer.

Feel free to give me a call or txt 07557506645

http://i1143.photobucket.com/albums/n622/Reno5gtt/IMG_1092_zpsad497c6d.jpg

http://i1143.photobucket.com/albums/n622/Reno5gtt/IMG_1094_zps2ebb848a.jpg


http://i1143.photobucket.com/albums/n622/Reno5gtt/IMG_1098_zpse5cc6674.jpg

http://i1143.photobucket.com/albums/n622/Reno5gtt/IMG_1097_zpsb00601f0.jpg

[BILLY-R5GTT]

http://www.ebay.co.uk/itm/121124413664?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649

It's been ebay'd, found another car. Just looking for a straight sale.

[turbo ted]

hi there
is there any forged internals in this engine?

[JP Racing]

hi there
is there any forged internals in this engine?

Ted if you look on the eBay advert there is a receipt for work done and the last bit on it says machined pistons and head to achieve the required compression ratio :/ so I would say no forged internals.

[BILLY-R5GTT]

No forged internals, but I am open to sensible offers and willing to take quite a drop on it.

Bought a 56 reg impreza wrx sti last night... The engine is getting in the way now since the workshop has gone.

Feel free to make me an offer on everything.

[paul5gtturbo86]

would this drop into a 5 and if so what else would i need ie loom etc?

[Markey Mark (BD)]

would this drop into a 5 and if so what else would i need ie loom etc?

They can fit the 5 mate

Going by the advert you'll need
-ecu and wiring loom
-injectors and rail
-fuel pressure regulator
-bigger fuel pump
-turbo and new downpipe
-throttle body
-intercooler
-rad
-all pipework
-engine mount
-gearbox (if you not got one already)

Sure there be few extra bits I've missed

[BILLY-R5GTT]

Come on someone must want this engine!! I am open to sensible offers and it might be cheaper than you think. Stop wasting money on your unreliable c1j and get some real power under the bonnet ;).

[andybond]

What happened on ebay fella ?

[w35ty]

Would love it mate! Just aint got the money to get all the other bits + tuning :crap:

[BILLY-R5GTT]

Buyer changed his mind after finding out how much it would cost to finish the conversion.

[BILLY-R5GTT]

Would anyone give me £1300 for the lot?

[KEV 5 GT]

how much is the rest gonna cost me to get it running mate ?

[BILLY-R5GTT]

If you bought everything off here second hand I reckon around £1200 give or take, depending what's coming up for breaking etc... If you were going for everything brand new like I was going to do in the region of 3k

[KEV 5 GT]

can you list whats needed for completion as im looking for big power

[BILLY-R5GTT]

They can fit the 5 mate

Going by the advert you'll need
-ecu and wiring loom
-injectors and rail
-fuel pressure regulator
-bigger fuel pump
-turbo and new downpipe
-throttle body
-intercooler
-rad
-all pipework
-engine mount
-gearbox (if you not got one already)

Sure there be few extra bits I've missed

Heres your list mate

[KEV 5 GT]

will do some homework and get back to you mate