turbo and starter motor heat shield fitting

[Flight666]

Hi Guys I`m having a bit of a wrestle trying to fit the Starter motor and Turbo heat shields to my 5 addmitedly I`ve only had a few mins meddling here and there but can I buggery fathom out how to wangle them into place, any help of the best route/bits to remove would be greatly appreciated as I want to tick them off my list of jobs to do and they are both new so don`t want to bust them.Also does anyone know where the hot air feed pipe bracket bolts to,this hot air feed bracket itself has a flat stainless steel plate bolted to it (from my box of spares so no idea if I need this s/steel part or not) thanks v much in advance for any tips..:)

[markey b]

I find easiest was to get starter out is to undo lower shock mount bolt and remove top one, then u can pull hub down to get driveshaft off gearbox spline, then unbold starter from top and remove from underneath :-)

[markey b]

Re read the actual post! Starter heatsheild bolts onto block I think, although I don't run one

[Flight666]

Cheers Markey Yep I can see the mounting points for the heatshield just seems a tight squeeze getting it anywhere near..many thanks for the info regarding removal of starter itself, for if and when I need it removing did cross my mind when I saw where it was fitted..

[Flight666]

Surely one of you guys has fitted a turbo heatshield just had a go again, starter shield all fitted but still struggling as to how to get the turbo one in and also where the hot air feed pipe bolts to thanks in advance if anyone can keep me right..