Sandwich Plate Fittings

[Nick k]

Does any know what size the fittings are on a 5' C1J sandwich plate as im planning to run an external oil cooler with braided pipes?? 1/2" ?? Cheers.

[Andy M]

The OE plate is certainly metric but can't remember the exact size I'm afraid, M14 x 1 seems to ring a bell but can't be 100% sure. I bought some fittings from Think a few years ago for the same job. Will have a dig tomorrow.

[Nick k]

The OE plate is certainly metric but can't remember the exact size I'm afraid, M14 x 1 seems to ring a bell but can't be 100% sure. I bought some fittings from Think a few years ago for the same job. Will have a dig tomorrow.

Ok cheers

[Andy M]

I couldn't find the oil cooler pipes for the life of me, turned my parents garrage upside down hunting for them!

Found an old plate though and measured that instead! M18 x 1.5 so was close 1st time round :rolleyes:

Plenty of choice in fittings, I went for a male to male threaded adapter in the plate, then used 1/2" push on fittings to make life easier fitting / removing.

Have these spare that may be of use, if you want them send an sae with a token couple of quid and i'll post them back

http://i1301.photobucket.com/albums/ag110/andy_slay/20C4CE45-6933-40A4-9B71-FE9B11C138EF-3676-00000845CC63872F_zpsad8c4e61.jpg

[RSi SiDs 480]

I couldn't find the oil cooler pipes for the life of me, turned my parents garrage upside down hunting for them!

Found an old plate though and measured that instead! M16 x 1.5 so was close 1st time round :rolleyes:

Plenty of choice in fittings, I went for a male to male threaded adapter in the plate, then used 1/2" push on fittings to make life easier fitting / removing.

Have these spare that may be of use, if you want them send an sae with a token couple of quid and i'll post them back

http://i1301.photobucket.com/albums/ag110/andy_slay/20C4CE45-6933-40A4-9B71-FE9B11C138EF-3676-00000845CC63872F_zpsad8c4e61.jpg
These will come in useful!,how much u want for them chief?

[markey b]

If u search boards I'm sure I asked same question and updated it when I found out :-)

[Nick k]

Sorry Andy did'nt see your reply mate, Will them fitting screw into the sandwich plate ??