phase 2 seats

[casper]

I have a good spare passenger seat I want to use to make my drivers seat mint.Is it simple to swap the bolsters over,or should I just swap the whole seat.:dearme:

[Bigfoot]

The levers are wrong side, You can swap over bolsters, even the bolster material, cant swap over the backs though due to where the holes are, but you can if you want to get one mint is unstitch the material and make a good one between the two depending on where or if there are any holes.

[fossie]

Have a look on eBay matey. Someone was selling the fabrics on there brand new which would be a good start

[Robbo]

the bolsters tend to start dropping to bits as you remove them

[casper]

Basically iv got two interiors,the existing one is very good apart from drivers seat and that isn't too bad.And iv got a spare which has a not so good drivers seat but a mint passenger seat.Not sure on the best route to take to get one mint one.:confused: