PDA

View Full Version : Negative coil feed ?


Leigh
16-12-2008, 13:19
Ive got a rev limiter with this launch control option and in the instructions it says to connect to the coil negative feed :scared: and unless im blind ive looked in my Haynes manual and now got the coil off and still cant see where im meant to be connecting it. Any help would be good as its bloody cold out here :D

Thanks Leigh
Sparkie
16-12-2008, 13:31
look at the coil carefully....
Leigh
16-12-2008, 15:04
look at the coil carefully....

Ive looked and i will now re word what i was meant to say.... :D Right i have found the actual Neg feed i need to connect it to but cant see a easy way to do so, as looks to be a sealed unit.

Cheers Leigh
Sparkie
16-12-2008, 15:36
create a loop in the wire you need to attach to the coil. then push the loop over one of the spring clips that hold onto the ign coil peg.... then twist the wire, this tightens the loop...voila.
RussellT
16-12-2008, 16:59
there is a neg feed peg hidden under a foam plug on the side of the ECU. A female connector will clip over it
Mart
16-12-2008, 17:35
Slip a non-insulated bullet connector (*) over the pin, then refit the coil-pack to the aei base.

* Look like these (but non-insulated): http://www.toolstation.com/images/library/stock/webbig/28314.jpg
Sparkie
16-12-2008, 18:48
nice one mart, ill remember that one :agree:
Leigh
17-12-2008, 09:10
Slip a non-insulated bullet connector (*) over the pin, then refit the coil-pack to the aei base.

* Look like these (but non-insulated): http://www.toolstation.com/images/library/stock/webbig/28314.jpg

Good thinking :D
Mart
17-12-2008, 10:04
I should've added, you might have to cut away a bit of the plastic surround to allow the bullet connector to 'stick out' from the coilpack. You'll see what I mean when you fit it...
Leigh
17-12-2008, 10:36
I should've added, you might have to cut away a bit of the plastic surround to allow the bullet connector to 'stick out' from the coilpack. You'll see what I mean when you fit it...

Yeah all done and put back together thanks for the help.