Kingscott
08-11-2012, 18:09
Hi Guys
My original rear comp valve has finally died after 20 plus years so I've decided to fit a manual valve in the car.
(My car is non road legal, track only)
My question is, how do I plumb in internal brake lines? Do I run just one line to the rear and split then blank off one output off the master cylinder?
If anyone has internal lines or a manual brake bias valve fitted can you please give me some pointers on where to start? clips, entrance and exit points, materials used.
Any help would be super fab.
Cheers
Adam
My original rear comp valve has finally died after 20 plus years so I've decided to fit a manual valve in the car.
(My car is non road legal, track only)
My question is, how do I plumb in internal brake lines? Do I run just one line to the rear and split then blank off one output off the master cylinder?
If anyone has internal lines or a manual brake bias valve fitted can you please give me some pointers on where to start? clips, entrance and exit points, materials used.
Any help would be super fab.
Cheers
Adam