PDA

View Full Version : lm1 wont calibrate


djinuk
28-08-2012, 12:09
my lm1 , wont perform free air calibration, it was working fine , but now the calibrate button has no effect at all.
Kris M
28-08-2012, 17:59
I presume you are holding it down and not just pressing it ? :)
djinuk
31-08-2012, 11:31
yea bud.. it has no effect, holding it, pressing it repeatidly.. grrr.. looked on the internet and theres a few people with the same issues, going to try reinstalling the firmware i think .
Scoff
31-08-2012, 11:41
Innovate = headache :( Just be glad you didn't spend 350 on a new LM2 when they came out only to find it was total junk. Good luck with it. Maybe check the button itself is working still.
djinuk
31-08-2012, 12:10
im feeling that aswell :(, sold my lc1 to get a nice reliable lm1.. now i have issues with this, its probably had less than 2 hours use, unfortunatly over the space of 2 years.
Sparkie
31-08-2012, 12:59
scoff - your old LM1 is still working :)
djinuk
27-09-2012, 09:35
just to update.

I sorted this..

the Lm programmer software has a button called reset calibration (this removes all the old calibration data), after that its working again. :)
markey b
27-09-2012, 10:20
Innovate = headache :( Just be glad you didn't spend 350 on a new LM2 when they came out only to find it was total junk. Good luck with it. Maybe check the button itself is working still.

my LC1 lasted minutes, binned it and got an AEM.. so much simpler, no setup and much prettier too :agree: