PDA

View Full Version : H330 UAA - What is needed?



Romil Davda
06-08-2012, 17:47
Owned the car for around 8years now and she has been on the road for just over 8months. Thought I would keep a track of work done, as well as list what is needed and nice to haves:

November 2011 - (£450) to get car thro MOT. Markey Mark helped pull the car out of a bush and did the work required.

December 2011 - Bought an engine off eBay (£750), suppose to have low comp pistons, high lift cam, knife edge crank, etc... (not forged)

February 2012 - HID XENON Conversion Kit (£50), Short shifter (£35), random bits off ebay (bonnet, body kit, strut brace, side exit, 2 1/4 inch down pipe) (£450), AEM UEGO (£150)

March 2012 - Engine bought back in December was put in (£250). Raceland Tubular Manifold, with new gasket and nuts (£200)

April/May 2012 - Grooved disk all round (£100), More random bits (braided brake lines, oil pressure gauge, rear spoiler, dump valve, boost gauges) - £300

Rover Tomcat 200 Turbo (T25) unit = (£10 - eBay) - REBUILD (£350). Adaptor for oil feed £30, new oil, filter, gasket - (£40)

Jun 2012 - Bought BMS downpipe (£230) and external oil cooler (£100). Armtech rev limiter (£50)


To fit:
· Short Shifter Pin
· Oil Pressure Gauge
· Braided brake lines/hoses
· Side skirt clips
· Rear arch
· twin headlights - Want to make up XENON Angel eyes, plus need standard bonnet
· boot release to fit and wire in
· Fix AJ tuning front bumper and fit
· Fit rear bumper


Nice to have:

200 BHP
220 Toruqe
clean car all round (paint and interior)
Exhaust braket under car fixed
Never having to use "cable tie" to keep my car together/on the road

TBC...

Tony Walker
06-08-2012, 21:24
My bet is the person who invented the cable tie owned a 5

Phoenix Autosport
06-08-2012, 23:55
My bet is the person who invented the cable tie owned a 5
aint that the truth, probably had shares in rust remover too :cry: