Swirl Pot Bracket.

[Matt Cole]

Chaps,

Anyone got a pic of where the swirl pot brackets bolts too?

I can't remember as i'm old.:scared:

[chris]

Was that the one for the water degass chamber

[Brigsy]

Bolts to the lower headlamp fixing bolt matey

[markey b]

Bolts to the lower headlamp fixing bolt matey

:agree:

[Chunk]

I don't have any of these brackets, zip ties ftw!

[Brigsy]

I just removed the water swirl pot altogether with no ill effects :)

[Big Steve - Raider]

I just removed the water swirl pot altogether with no ill effects :)

Do explain more Mr Briggs....?

What do you do with the three pipes that go to it then??

[Brigsy]

Pipe from heater matrix goes to top of water pump (ideally needs a bleed nipple fitting unless you backfill the matrix/pump like i do) bin the pot and associated pipework, block off return to the header tank job done;)

[djinuk]

Pipe from heater matrix goes to top of water pump (ideally needs a bleed nipple fitting unless you backfill the matrix/pump like i do) bin the pot and associated pipework, block off return to the header tank job done;)

i was studying this setup at fcs on the van and it does look very good.

[Brigsy]

It works fine too, ive done a few track days and loads of fast road driving the temp stays the same as before removing it. When i done a couple of sessions at donnington the temp never went above half way even at 120+ on the main straight.