Chris Holt
20-06-2012, 21:23
Hi,
So the phase 2 has just come out of storage as after getting an insurance quote of 150 fully comp so there was no excuse,
The spec so far, rebuilt the engine last year with new pistons and liners (standard) all new gaskets,full bottom end thrust bearings etc etc, standard head, double intercooler, afr, oil cooler, upgraded rad, i i think its a t25 front end with 360 bearing, engine has been bedded in. Oh it has a refurb carb with tweaked jets-( cant recal set up)
Anyway I am getting a piper 285 cam put in along with a new heavy clutch as it started to slip last year. I need to know what is the correct way to bedding in a new cam.
Thanks
Chris
So the phase 2 has just come out of storage as after getting an insurance quote of 150 fully comp so there was no excuse,
The spec so far, rebuilt the engine last year with new pistons and liners (standard) all new gaskets,full bottom end thrust bearings etc etc, standard head, double intercooler, afr, oil cooler, upgraded rad, i i think its a t25 front end with 360 bearing, engine has been bedded in. Oh it has a refurb carb with tweaked jets-( cant recal set up)
Anyway I am getting a piper 285 cam put in along with a new heavy clutch as it started to slip last year. I need to know what is the correct way to bedding in a new cam.
Thanks
Chris