PDA

View Full Version : Clunk noise + brake advice.



SirSamuelOfBuca
25-05-2012, 10:16
When I put foot down I get clunk from what I think is drive shaft.

I changed to a new drive shaft while doing this noticed suspension top mount was cracked.

After taking it apart found whole lot has gone. Replaced that.

Still get a clunk from what I think is the drive shaft. :S

Its definitely not a mount, had it over pit and checked everything.

When I put foot on throttle its just a clunk. :S

Other question is my brakes are terrible. They have been on the to do list for a while. Front pads have lots left. rear need changing. but when i say bad I have to pre emptive brake from ages away. This is with EBC green stuff pads and vented discs.

What would cause them to be about 20% efficiency at last mot just passed (before i brought car).

I am thinking bleed them refill with fluid and change rear pads should sort it?

SCHWARTZ
25-05-2012, 18:21
One way valve in the inlet to servo still working? Poss duff servo or MS.

TNT ANDY
25-05-2012, 19:00
I had this once in a mini - turned out to be a can of Fosters under my seat:D

SirSamuelOfBuca
25-05-2012, 19:25
Cheers I'll check it. What order is it to bleed brakes?

Pedel doesn't push in very far so reckon u might be right.

Still gna bleed n refill tomoz