Regarding cluster pinout

[chipis]

swaping non turbo renault 11 (without rpm, water temp, oil press) cluster to turbo cluster. maybe someone has any pinouts of these both clusters? would like to make the new one working

[chipis]

maybe someone could help and tell if these contacts are for tacho on the cluster?
http://desmond.imageshack.us/Himg26/scaled.php?server=26&filename=14191899.jpg&res=landing

[Woznaldo]

Pretty sure they are for the tacho.

Have a look in the files section, then go to technical, then wire diagrams. There is almost everything R5 in there (GTT and other models) so have a look and see if you can get the info you're after from there.

;)

[Brigsy]

One of the wires on the blocks at the top runs the tacho, i wired mine up myself and didnt fit the 2 pin connector.

I cant remember which wire does what though as it was 4 years ago when i done the conversion :ashamed:

[Woznaldo]

Brigsy is indeed right. See the diagrams below:

http://www.rtoc.org/files/Technical%20Files/Wiring%20diagrams/WD033%20REVS%20COUNTER.JPG

http://www.rtoc.org/files/Technical%20Files/Wiring%20diagrams/Instrument%20Panel%20Connectors.jpg

MA = mauve (pink)

Pin 8 on the 13 Pin Connector is the one you want (tach input)
Pin 9 on the 9 Pin Connector is the Instrument Panel general earth for everything in the Panel.

Hope that gets you sorted. ;)

[markey b]

i was gonna say its a brown i think on the connector on the top

the one in the pic is oil level if im correct?

[chipis]

maybe someone will know better:
http://desmond.imageshack.us/Himg338/scaled.php?server=338&filename=44021286.jpg&res=landing
should that only one brown wire come to those connections in the cluster back?

[chipis]

maybe someone could give me any clues what could be wrong with my tacho. i have connected adaptronic ecu to the rev counter wire in the ignitor control module and adaptronic shows me revs good. also i have connected directly rev counting wire to the cluster 8 pin, as showed before in the picture. and tacho do not shows revolutions, when switching beams, or acc power tacho pointer instantly moves a little, but do not shows anything more. maybe anyone could comment regarding this matters? could be any fault inside tachometer? i gues if it moves a little it shows that some kind of contact there is?

[chipis]

maybe it might be not working if i have disconnected distributor cap with rotor from the ignition module?