engine wirring issues

[gttjames]

Got my engine back in and at the point where im reffitting wirring loom, was a while back i removed engine and the wirring loom was piss poor, a few connectors pretty much fell off in my hand etc but now iv come to re do it all cant queite remember where it all goes, so if anyone can help with the following...

What colour wires go to the sensor in sump

what colour wires go to oil pressure block thing on front of block

what colour wires go to rad fan switch - RED goes to alterntor +, orange to fan relay???

Which colour wires go to alternator clip - rellow closest to engine terminal, purple - closest to rad terminal


http://i15.photobucket.com/albums/a371/sr50james/volvo5018.jpg

[chezzer85]

http://www.rtoc.org/files/Technical%20Files/Wiring%20diagrams/Missing%20Haynes%20page%204%20%28Wiring%29.jpg

Out of the blue haynes manual, codes are explained in any haynes,
Just done my loom and think the oil warning light was two orange wires connected to a connection block and the oil pressure sensor was two orange wires on seperate spade connector tabs. can't mess them up as oil warning light doesn't fit on pressure sensor.

Will have a look in a bit and conferm

[chezzer85]

The rad fan switch on mine is a purple wire and a smaller orange wire,
and ur correct yellow nearer block and purple towards rad. (tho my battery light doesn't seem to work)

[gttjames]

did you look at oil pressure sensor in sump, and oil level/pressure on front of block?

cheers

[gttjames]

iv checked the wiring diagrams but problem is the level sensor in sump is very close to the oil pressure sensor

and the wires going to the oil pressure switch by the haynes are brown and clear, and the other sensor are orange and brown.... so basically i have 2 wires (brown) in same area, if they are both earth's does it not matter which sensor i get them on?

cheers