turbo oil feed question

[Bunje]

hi there
i recently picked up a turbo technics t2 off ebay its virtually the same as the turbo i have but mine is shot so i thought it would be straight swap over but the section where the oil feed and water cooling is different as in its like spun around 90 degrees so the oil feed inlet is on the side instead of the top. and the drain is on the side aswell will this cause me any problems or isit justa case of goin to pirtek and having a new oil feed pipe made up

cheers for the help in advance
Ben

[SCHWARTZ]

Undo the bolts on the exhaust housing and spin the core round. Then do the same to comp housing.

[Bunje]

i thought it was going to be as simple as that but there are no bolts ill see if i can upload a pic

[Bunje]

after some further reading on here i found out its held togethere with two big circlips

[SCHWARTZ]

Same applys just circlip instead of bolts then.