stripping a turbo unit.?

[raj]

OOOkay!

well straight to the point, i had 5 old turbos sitting on the shelf in the garage, all in need of a rebuild.

now ive managed to remove all parts including housings from 4 units but with 1 snapped bolt in the exhaust housing:rolleyes: i assume ill have to drill this out:crap:

i have one unit left to strip, the issue is the turbine housing bolts, 2 have come undone but the other 2 do not want to move. ive tried but ive ended up rounding the bolt heads:crap:.
how exactly can i get these bolts out.? also the bolts were soaked in plus gas for days before i tried.
i wonder how turbo companies strip units?
the must be a hack to stripping units? as these turbine side bolts have been a nightmare on all of the units:brickwall:

[djinuk]

not sure in particuler on turbos but the following methods have worked for me in the past.

Welding spanners/sockets to them, hammer and chisel.

[Alastair]

BLOW TORCH before you start...

[raider_gtt]

BLOW TORCH before you start...

I 2nd this one! Done this a few times

[tubbyG]

Do you have enough room to get an extractor socket on?

[raj]

BLOW TORCH before you start...

i would if i had one:D any ideas on a cheap n cheerful blow torch.?

[raj]

Do you have enough room to get an extractor socket on?

that'll be a no:(

[raj]

not sure in particuler on turbos but the following methods have worked for me in the past.

Welding spanners/sockets to them, hammer and chisel.

im using a hammer and chisel at the moment but i just dont have the patients now.
:crap: