engine dies help [Archive]

blaze

24-08-2011, 18:18

i have a prob with my engine which is when it starts to warm up the engine cuts off as if you have switched the ignition off when you havent, has anyone had the same problem or have any ideas

blaze

24-08-2011, 18:52

forgot to say when it goes cold it starts and runs till it gets warm again

Ashy

13-04-2013, 22:01

Mines doing this, any ideas?

Only thing that's got me stumped is the coolant temp sensor, where is it?

Tony Walker

13-04-2013, 22:23

lol i shouldnt presume everyone has a c1j.

SCHWARTZ

13-04-2013, 22:35

Coolant temp sensor is in the head this gives the ecu the signal. Check icv if you have it in. What is the maf adjusted to? Sounds like it is dying when it comes off choke

Ashy

13-04-2013, 23:16

Coolant temp sensor is in the head this gives the ecu the signal. Check icv if you have it in. What is the maf adjusted to? Sounds like it is dying when it comes off choke

Side or front?

I've got a 2pin (like an injector) connector on the front (flywheel end) but it looks more like a knock sensor then a single pin one on the end of the head above the thermostat housing (which looks more like a temp sensor) but my loom doesn't seem to have a connector to fit it?