tubby5
18-06-2011, 16:14
ok guys,heres my problem,
i have just finished putting the toyota engine back in my 5.and when i pulled out of the garage it started to miss and then cut out.and it does this all the time,so i started it up and thought i would push it out and it did exactly the same:confused:
i have checked for dangleing wires near drive shafts and there isnt any.i have also give the loom a good shake and nothing.but as soon as soon as i push it it misses and dies,and it doesnt make a difference if i hold the revs at 3k it still misses and tries cutting out:scratch:
i am really lost,any ideas???
i have just finished putting the toyota engine back in my 5.and when i pulled out of the garage it started to miss and then cut out.and it does this all the time,so i started it up and thought i would push it out and it did exactly the same:confused:
i have checked for dangleing wires near drive shafts and there isnt any.i have also give the loom a good shake and nothing.but as soon as soon as i push it it misses and dies,and it doesnt make a difference if i hold the revs at 3k it still misses and tries cutting out:scratch:
i am really lost,any ideas???