PDA

View Full Version : Is this a fault??


REBEL GT TURBO
24-03-2011, 20:34
Right i'm not getting any spark at the plugs!

New NGK plugs
High performace HT leads

The order is correct.

Ive noticed the starter motor is making some (on its way out) noises but is still turning!

I took the dizzy cap off and it was clean, The thing is should the rotor arm spin fast???
I turned it over while the cap was removed and the rotor arm is turning really slowly!:confused: I would have thought it should spin really fast to hit the points on the cap!
REBEL GT TURBO
24-03-2011, 20:51
I think the battery is low! ive charged it but it doesnt sound like its right! i'll get a new one tomoz!!:agree:
Bigfoot
24-03-2011, 22:08
Are you checking spark from the king lead or from any of the HT leads as it doesn't matter how fast the rotor arm goes round if your not getting any spark to the dizzy cap.
REBEL GT TURBO
24-03-2011, 22:16
Are you checking spark from the king lead or from any of the HT leads as it doesn't matter how fast the rotor arm goes round if your not getting any spark to the dizzy cap.

Which is the king lead?? :scratch: I used the lead going to the plug on the rhs of the engine (looking from the front)
5teve L
24-03-2011, 22:20
TDC sensor or coilpack gone
Tony Walker
24-03-2011, 23:01
The KING of the leads ;) lol main one going to the middle of the dizzy from the coil in the AEI.
REBEL GT TURBO
24-03-2011, 23:44
The KING of the leads ;) lol main one going to the middle of the dizzy from the coil in the AEI.


right i thought it was that one!:scared:;)

If i use a volt meter on the end of the knig (main) lead and ground should i be getting 12/13 volts when turning over???
IANMM
25-03-2011, 08:13
just put it onto a metal point of the engine and look for the spark....dont use a volt meter mate

oh and make sure its a good earth point :)
Trevhib
25-03-2011, 09:55
"Could be leads, king lead, AEI, AEI relay, overboost circuit short..."

From the other thread.

This means checking/replacing king lead, swapping AEI over for a known good one, replacing AEI relay (in scuttle panel under bonnet catch) and disconnecting the overboost circuit from the AEI.

Then report.
Mart
25-03-2011, 10:00
TDC sensor

:agree:
REBEL GT TURBO
25-03-2011, 21:12
Sorted it!:agree:
Trevhib
25-03-2011, 22:54
Erm, what was it? :rolleyes:
REBEL GT TURBO
27-03-2011, 00:14
Erm, what was it? :rolleyes:

Me!:rolleyes: