Driveshaft stuck on gearbox

[Winston]

I can not get the Drivers side shaft off my Williams gearbox... the roll pin was hard enuff to removed and once i removed it the shaft will still not budge off the gearbox

Ive tryed taping the shaft with a long chissel and a hammer to try and knock it off... but scared of damaging the gearbox

Im not bothered about the driveshaft... I would be happy to butcher it to save the box

any help will be greatly aprechated :smokin:

[dangerous dave]

heat, plus gas, soak in wd40, pry bar, whack it..



or remove the boot/shaft and leave the stumpy bit on

[TommyB]

Not to sound stupid but you have taken out both roll pins?

Most of the cars i've done have has a roll pin inside a roll pin.

[Winston]

Its been plus gassed and had mucho heat to get the roll pin out... more can't do any harm lol

All the roll pin (both parts) is deffo out... I hate them so much :laugh:

I will remove the boot and continue the same... Im at point of wanting to cut it off lol

[Brigsy]

Persuade it off with a hammer, i had a similar experience in the past.

[Schakal]

remove the inner boot along with 3/4 s of the shaft than
try some sort of PMT setup to push the remaining end off the
gearbox using some reno jacks etc :smokin::smokin:

:coffee:

[Winston]

http://mn3020.k12.sd.us/Year/M.C.%20Hammer.jpg

[paul b]

http://i88.photobucket.com/albums/k168/paulb69_2006/mchammer.jpg

[Schakal]

http://img.photobucket.com/albums/v402/TwistedFortune/Test/41oct17-something-aint-rigth.jpg

[paul b]

LOL...........

at least the "hammer time" reference was valid for the thread.....LOL....

so thats how make chocolate cheerios..