PDA

View Full Version : 3 litre EFI GTA



clee
30-01-2011, 14:03
Just in case I get bored with JIL and restoring another Atmo GTA for one of the RAOC lads......Needing to keep busy I have started this conversion .
Grey Atmo that needs paint and headlight glasses but otherwise sound .

http://i193.photobucket.com/albums/z110/cleetav6/IMG_0382.jpg
http://i193.photobucket.com/albums/z110/cleetav6/IMG_0386.jpg
http://i193.photobucket.com/albums/z110/cleetav6/IMG_0384.jpg

3 litre evenfire to drop in .Remove balance gear and Hyd rockers ,fit new cams , solid rocker gear and swap bottom plate over to GTA .ECU ,bit of wiring for that and fuel pump ..
Should be a quick little car when done :twisted:
http://www.rtoc.org/boards/[img]http://i193.photobucket.com/albums/z110/cleetav6/IMG_0379.jpghttp://i193.photobucket.com/albums/z110/cleetav6/IMG_0379.jpg

http://i193.photobucket.com/albums/z110/cleetav6/MaFa/IMG_0569.jpg
http://i193.photobucket.com/albums/z110/cleetav6/MaFa/IMG_0568.jpg

mike r5 gtt
02-02-2011, 20:11
i think iv only ever seen two of these in the flesh!
u seem to have a secret supply of gta's!:D
looks really clean :agree:

clee
02-02-2011, 21:19
4 1/2 here at the minute and another on the way :scared:
Luckily they aren't all mine or I'd be living in one :laugh:

Engine done for this .Original plenum will fit I think after some careful measuring by Claude :coffee: Throttle spindle should clear the bulkhead and a good bendy pipe find takes it out back to the rear spoiler where the std carb intake is .
http://i193.photobucket.com/albums/z110/cleetav6/MaFa/IMG_0578.jpg
http://i193.photobucket.com/albums/z110/cleetav6/MaFa/IMG_0576.jpg

clee
03-02-2011, 17:44
Serendipity strikes with an ali plug ready made for the job :D Leftover froma change of plan on JIL .
So waterworks plugged and chopped short,need to get a 90 degree silicon to take the water over to the rhs to mate up with the matrix pipework .
http://i193.photobucket.com/albums/z110/cleetav6/MaFa/IMG_0584.jpg
http://i193.photobucket.com/albums/z110/cleetav6/MaFa/IMG_0583.jpg
Unforseen issues also meant that the balance gear caps have to come off so i've swapped them out for std GTA and also means std covers all round now .
http://i193.photobucket.com/albums/z110/cleetav6/MaFa/IMG0043A.jpg