Bearing/gear pullers

[clee]

I need to get a few bearing cases of a few hubs ...
Can anyone recommend a decent quality tool that will work more than feckin once ?
Bought a Clarke job, it worked once then has lost the knife edge and won't do the job again BAG-O-****E :mad:
http://www.machinemart.co.uk/images/library/product/large/04/040211225.jpg

[Tony Walker]

Do you mean the inner races off the stub axle or pulling the stub out of the bearing in the hub?

Easiest way to get the inner races off is grind it with a slitting disc, otherwise a press with a few odds and sods is best for getting the hubs apart and brearings out, u can pick up an old press pretty cheap

[Tony Walker]

lol, rtoc moving on, it just said thank you to me for posting???

[clee]

Have a thanks from me as well .
Need to get the inner race off . Will try and slit it ....
Local garage pressed the old lot out and new in for me but I'm left with half a casing stuck to the shaft .

[Tony Walker]

np, its the easiest way, takes 2 mins, just dont go too far :p ull have to do it on a bit of an angle too.

[Tony Walker]

:( they should of done that for you too, suprised they didnt take it off and press it back in? or did you request it seperate?

[clee]

I gave them the hub only to just swap the bearings out .Forgot about the bit left stuck to the shaft :o

[Tony Walker]

ah :) nevermind.

[Brigsy]

I just carefully grind the inner race off, miles easier than struggling to pull it off.

[clee]

Careful ,grinder and Me :laugh:

[andyrg]

mini grinder works a treat

[Adey aka Ewok]

Grind it thin then hit it with a chisel, works everytime for me