Standard wheel geometry

[Jimmy_GTT]

Hi,

I'd like to know the standard wheel geometry settings:
camber, toe out, ride height front/rear
For both ph1 and 2 if they are different.

Also interested about the recommended settings if they are different. (not only the ride height)

Thanks

[OCR]

New poster! (less than 10 posts)

I'm also interested in this (standard vs recommended). Maybe there is a service manual available that has these standard values ?

[jamie_8]

I can get the standard settings from work tomorrow :)

[markey b]

http://www.rtoc.org/boards/picture.php?albumid=1206&pictureid=14982

[OCR]

New poster! (less than 10 posts)

Thanks for the scan, but isn't "GTE" a different model from "GT Turbo" ? If they are different regarding suspension figures, could you also scan the page for GTT ?
Thanks

[BriC]

I thought the GTE was identical to the GT Turbo in terms of interior, brakes, suspension, etc.. just the engine and associate components were different

[markey b]

that was the only page covering all inc extra

[paul b]

GTE was a french spec...1.7 injected engine...had GT running gear as in suspension and brakes...

it got re-used in the Clio Rsi...

[Jimmy_GTT]

I think the GTE had the same suspension (shocks) as the phase I GTT.