How to remove the plastic sills?

[Jimmy_GTT]

How can I remove them not to brake the fastenings of the plastic seals?
(I hope you understand what I mean)

[michael tierney]

drill the rivet heads off at the bottom and then push the sill upward and the clips should release the sill(you must have the wheel arches removed first)

[Jimmy_GTT]

Thanks mate, but I'm afraid of those clips. The plastic can brake easily.
Isn't there a trick to save the plastic from breaking?

[J$£5GTT]

Thanks mate, but I'm afraid of those clips. The plastic can brake easily.
Isn't there a trick to save the plastic from breaking?



best advice as above,remove front an rear arches,you dont have to but it helps a great deal,of course you may break a clip or two,nothing to worry about,you can purchase repair kits or make your own....;),or get doner skirts if there real bad.
:)

[Matt Cole]

Heres a little tip on when you need to bolt the sills on again. I used plastic bolts and nuts. Dirt cheap and wont rust!! Nuts and bolts used for fixong number plates on will do.