re-working the bottom end

[scott 5gtt]

seing as though i wiped my bottom end out last week i was thinking about re-working it a little bit eg:- knife edging the crank / lightened fly wheel and fully balancing the lot has any one done this and what are the gains pros and cons .. going to machine shop tomorrow to have a chat se what the crack is ... also good day at mallory yesterday cheers rtoc..:D

[Brigsy]

Balancing & lightened flywheel are worth a look mate, wouldnt bother with knife edging personally though.

[scott 5gtt]

cheers briggsy definatley going to do that.. if it isnt to much more for the knife edge i might just try it ftw!!

bad luck with the fuel pump mate gives you an excuse to put a phase 1 on now though :D

seen your mallory picks bet them trophys are all polished on the old mantel peice lol.. well done on that score :agree: