Master cylinder / brake pipes

[philg]

Renewing brake pipes this week and i can not remember which way the pipes go into the master cylinder.

Nothing in the Haynes and doing a search.

Im guessing

1 is the pass rear
2 is the pass front
3 is the drivers rear
4 is the drivers front

Is that right?

Picture is taken from over the drivers wing :)

Thanks phil

[Andrew Cooke]

I can't remember what's right, but your guess if def wrong. The circuit is diagonal split, so the front pair will either be LF and RR, or RF and LR etc...

[dangerous dave]

3 - drivers front
2 - pass front

1 and 4 are the rears

4 goes to the right rear bias valve port, 1 goes in the left rear bias port while looking at the car from the rear.

4 is m12 1mm thread 3/16
1 is m10 1mm thread 3/16 for the pipe.

The front right port on the bias while looking from the rear is m12 and goes to the drivers rear caliper

Front left bias port is m10, goes to the pass rear.

Hope that all makes sense.

[philg]

got it, thanks again dave :)