PDA

View Full Version : wheel fitment


wolvo
05-07-2010, 10:23
Still trying to shift my wheels so can anyone tell me what other cars my renault 5 wheels will fit (17" Kahn) or advise me what "fitment" they are so i can include this information in my sales add when i advertise them localy many thanks mart. (still looking for an exchange for some 15" if anyone interested)
http://i756.photobucket.com/albums/xx205/mwolvo/Current%20Ride%20R5%20GT%20T/DSCF4705.jpg
James5
05-07-2010, 10:37
Well if they fit the 5gtt they must be 4 stud, PCD 100 I think the R5 is ET35, being Renault fitment they should fit some other renault model;s like the clio 16v, etc and some other manufatures ti name a few like Rover tomcats, Vauxhalls, to name a few
kayzee
05-07-2010, 18:54
These are ones that fit according to a place just down the road to me!

http://www.alloywheels.com/search.asp?numrecordposition=1&strSize=15%22&strkeywords=4x100%20et37,4x100%20et38,4x100%20et40 ,4x100%20et42,4x100%20et45&strSort=Low&Make=Renault&Model=Super%205%20GT%20Turbo
Adam L
05-07-2010, 19:52
Most wheels give the sizes on the back of them. They'll include width, et and height. If they're Renault fitment, the pcd measurements are going to be 4x100, as James mentioned.
Shane P
05-07-2010, 20:00
Well if they fit the 5gtt they must be 4 stud, PCD 100 I think the R5 is ET35, being Renault fitment they should fit some other renault model;s like the clio 16v, etc and some other manufatures ti name a few like Rover tomcats, Vauxhalls, to name a few

:agree:

4x100

ET35

Centre bore 60.1mm
Adam L
05-07-2010, 21:16
The centre bore is more than likely an accommodated size, in most cases vastly oversized, in which case you run spigot rings. It's very unlikely the centre bore is 60.1mm in other words.

Just take a wheel off, like I said, and I bet it's got all the info you need moulded into the back of it.
James5
05-07-2010, 21:29
The centre bore is more than likely an accommodated size, in most cases vastly oversized, in which case you run spigot rings. It's very unlikely the centre bore is 60.1mm in other words.

Just take a wheel off, like I said, and I bet it's got all the info you need moulded into the back of it.


:agree: