Turbo oil feed problem???

[TNT ANDY]

I have just put a T28 on the 5 which was supplied C/W braided oil feed pipe. The take off point on the block is 4- 4.5mm and the new inlet on the turbo is 7mm. The new oil feed is much too big and also the wrong gender for the existing take off point, any ideas chaps?

I assume I will need to make / replace the existing take off point to cater for the larger supply to the larger frame?
:confused:

[TNT ANDY]

Ok another way of asking.

What oil feed do most people run on there T28 / T3's?
:confused:

[youngscottie]

take the lot to pirtek or any hydroilc hose supplier and get the relevent adaptor
thats what most people have done;)

[Os8472]

take the lot to pirtek or any hydroilc hose supplier and get the relevent adaptor
thats what most people have done;)


:agree: thats what I did except I used hose solutions in bury to sort my T28

[TNT ANDY]

Cheers guys, but did you still keep the smaller / Original take off point from the block?:crap::confused:

[Os8472]

Cheers guys, but did you still keep the smaller / Original take off point from the block?:crap::confused:

yes