PDA

View Full Version : side exits


Ross99
14-10-2008, 19:11
whats the opinion on the powerflow side exit system is it worth a change? i have a general stainless out the back jobby?
Markey Mark (BD)
14-10-2008, 20:47
whats the opinion on the powerflow side exit system is it worth a change? i have a general stainless out the back jobby?

I've had bad experience's with Powerflow in the past so not really into there stuff. They don't make a system as such, all there exhausts are custom made on the spot so no 2 are the same.
James5
14-10-2008, 20:50
Got a custom 2.5" powerflow side exit on my GTT just bloody loud but I do like thankfully it's not the main car:agree:
Andrew Cooke
14-10-2008, 20:53
I've had bad experience's with Powerflow in the past so not really into there stuff. They don't make a system as such, all there exhausts are custom made on the spot so no 2 are the same.

when I investigated getting an exhaust for my bus they told me they just graft onto my original downpipe as "they never rust". I'd put them down as shiney ****e.
Markey Mark (BD)
14-10-2008, 21:09
when I investigated getting an exhaust for my bus they told me they just graft onto my original downpipe as "they never rust". I'd put them down as shiney ****e.

Sounds like what they done to mine mate with the downpipe, mine had about 30 bends in it and a silencer which was 1.75" bore when i had a 2.5" system made:sad2: Piece of crap really.
car.crash
14-10-2008, 21:23
i dont rate powerflow at all, but bods old car, now james's was a good job.

the sooner i remove my sidey and fit a 2 1/2 rear exit the better as sideys piss me off now.
jaffa
14-10-2008, 21:28
they sell em at halfords m8......say no more :laugh: not as good as there tools...there ok.:)
Bod
14-10-2008, 21:28
The fella that did my side exit at powerflow in ST.Albans had two renault 5 gt turbos so knew his stuff and did a fantastic job cannot fault that system:cool:
gttjames
14-10-2008, 23:14
depends completley on the fitter...
Coops
14-10-2008, 23:31
New poster! (less than 10 posts)

i have a bbpt job on the clio, top piece of kit, altho my only compaint is the box in it is a bit big, and with the car being quite low it catches on speed bumps etc so i have split the welds on it a few times, easy fix tho, get the lads at work tac it back up again:smokin: