fitting tripple gauge holder.. help!

[djinuk]

I am currently fitting the triple gauge holder in my phase 2 r5, which goes in place of the center heaters, however due to how far back the gauges physically sit they will hit a part of the heater pipe work. Is there a easy/recommended way of removing this to allow them to fit.. Or would I be right in thinking a chisel and a hammer is the usual course of action..

[minty83]

i just cut the bit out in the middle of the heaters saved taking the dash out;)

[James5]

i just cut the bit out in the middle of the heaters saved taking the dash out;)

This is what I started to do then I got bored and left it 1/2 hanging out still works fine just not the best look:laugh:. Will get around to doing it properly soon:ashamed:.

[Brigsy]

I cut out part of the heater box with a hacksaw blade with the dash in situ. Don't forget to fix the flap for the cold air vents down.