Thread size for this bit

[James5]

I don't suppose anyone knows the threads size for this bit on a Garratt Turbo compressor housing?? (as I want to put a take off in its place)

[Spooky]

Do you need one of those by any chance? :D

[D4WNO]

Sukh, is this the one you got from Adey? Adey said he left it at yours when fitting that turbo. If so, Adam said last year that wanted the allen key back from him that came with it, it actually belongs to his colleague

[D4WNO]

James, Adam said he'll check the size later on. It's some weird imperial measurement and he's too drunk to think of it :laugh:

[D4WNO]

P.S - I feel like Adam's P.A sometimes :laugh:

[Spooky]

Sukh, is this the one you got from Adey? Adey said he left it at yours when fitting that turbo. If so, Adam said last year that wanted the allen key back from him that came with it, it actually belongs to his colleague

Really? I've only ever had one of those, it was already attached to a turbo though when I brought it :)

I do remember asking Ade for one of the nipples, managed to source one myself in the end :agree:

As for this allen key, I'm stumped :scratch:

:)

[michael tierney]

possibly a 1/8bsp(british standard pipe)...see is it the same as the water fitting for the inlet manifold!

[James5]

Do you need one of those by any chance? :D

:laugh: yeah

[James5]

James, Adam said he'll check the size later on. It's some weird imperial measurement and he's too drunk to think of it :laugh:

Dawn & Adam many thanks that would be fantastic :)

[D4WNO]

Don't thank me, I'm just the messenger :laugh:. Adam, (in his drunken state) says the 1/8 bsp sounds right but he doesn't check sizes anymore, just picks up the right tool for the job out of habit (geek)

[Spooky]

J, if I do happen to have one, you can have it, will check tomorrow :)