r5 heater controls

[jackw04_123]

does anybody know how i can attach the heater adjuster pulley cables onto the back of both the hot cold adjustment and the direction i.e floor window ect adjustment?????

[modfather]

theres some info in the haynes manual

[modfather]

this should help :)
this is what its says in the book adjust control knobs to distribute cool air as shown in the pic and postion the levers as shown with the special dots aligned where applicable.

[jackw04_123]

it doesnt actually tell you how to connect the cables onto the back of the heater adjusters though :crap:

[modfather]

the shorter cable goes to the postion of air flow and the longer 1 goes to hot/cold switch. the cables have round bits on the end and they should push onto rods on the back of the switches

[jackw04_123]

i think i may have some parts missing on the back of the controllers then :confused: because there is no obvious place to push the round bits onto

[modfather]

i got a panel some where round here i dig it out tomorrow and put up a pic of where the cables go :agree:

[jackw04_123]

thanks alot mate much appreciated :):):):)

[modfather]

hers the pic as promised where i have circled thats where the cables go

[jackw04_123]

well the problem seems to be that i havent got these wheel things which are attatched to the arm bit where the cable connects onto :confused:

[modfather]

oh dear thats a pain would you like to buy mine

[jackw04_123]

yes how much would you want posted?

[modfather]

pm me an offer :agree: