GTA in for MOT [Archive]

clee

08-12-2009, 12:46

Hope it passes as I need to pull it to bits :scratch:

J$£5GTT

08-12-2009, 15:06

hope the slag passes mate,gta hate the mot...:sad::dearme:

clee

08-12-2009, 15:28

:niceone:

Plate bulb and rear bearing ...I've got some hubs, complete with good bearings ,quick clean up and swap tomorrow. JD .

Mid Jan, engine swap and tune :cool:

markey b

08-12-2009, 18:48

what about a body kit.... here is a nice one

http://silverstone.fortunecity.com/studebaker/677/alpinehorror.jpg

clee

08-12-2009, 19:46

:scratch:

Scoff

08-12-2009, 19:49

Mid Jan, you must be close with the engine now ?

clee

08-12-2009, 20:07

Main lump is built . Ancillaries are all here .Turbo oil drain to modify .Starter motor test fit and mount ...that's about it apart from the intercooling .
I'm planing on getting it done by the new year so check your diary for a slot ..I know you like the crisp clear mornings :coffee:

Scoff

08-12-2009, 20:27

Main lump is built . Ancillaries are all here .Turbo oil drain to modify .Starter motor test fit and mount ...that's about it apart from the intercooling .
I'm planing on getting it done by the new year so check your diary for a slot ..I know you like the crisp clear mornings :coffee:

I'll pack the space heater this time :cooter:

clee

09-12-2009, 16:25

wuss ....you need to put some podge on Slim :p

Turns out the bearing was OK ...The hub nut had loosened itself ,re torqued and all good :coffee:
A tech note from Alpine was issued about it so a common problem it would seem .Bit scary though ,I will be making regular checks from now on .