Scorpion exhaust downpipe tapered flange size

[tiff_lee]

Does anyone know what size the tapered flange should be on the scorpion downpipe as mine appears to have been cut off and replaced with another from what I can only guess is a standard exhaust so it could be mated upto a standard downpipe?
http://i148.photobucket.com/albums/s4/tiff_lee_photos/Photo014.jpg

Only noticed it today when trying to fit my one piece downpipe as the scorpion exhaust flange only just about makes contact with the inner edge of the downpipe but does not seal at all for obvious reasons.

http://www.rtoc.org/boards/[IMG]http://i148.photobucket.com/albums/s4/tiff_lee_photos/Photo013.jpghttp://i148.photobucket.com/albums/s4/tiff_lee_photos/Photo013.jpg

[J8TRO]

I think its how the scorpion exhaust comes mate. i bought a enlarged down pipe, went to fit it and my scorpion was far too small to mate up. ended up buying a sidey to overcome the problem.

Mine looked exactly the same though, as if the flange had been welded on.

[gttjames]

Yep thats how all scorpion systems are (well mine are anyway).

Iv just got a bms, and boris sent me an adapter for it, maybe ask him where he gets them from, or go 2.5inch option.

Anyone got a nice 2.5 inch exhuast, rear exit?

[Junglist]

mine wouldnt mate up either ,,
also i asked boris for an adapter :agree: , im sure he will be able to tell you what size you need