Carb Service Kit

[Tom@SimplyAutomotive]

I noticed that when taking my foot of the accelerator that the car would almost stall. :(

I took the carb off and between the two gaskets there is a thick plastic gasket which has split, (only slightly) but i guess that causing it to stall.

Is there anything i can do temp before i leave for Germany this afternoon?

Cheers

[James5]

Tom,
It would be causing an air leak so yeah could be causing the stalling.
Pop around to me on my lunch break today @ 1pm I have a spare plastic block you can have matey.:cooter: If that isn't to late:D

[Tom@SimplyAutomotive]

:):):) Cheers James, Im not going to be able to have a lunch break today because im finishing early. Could i pick it up around 3.15 on the way to dover??

[James5]

:):):) Cheers James, Im not going to be able to have a lunch break today because im finishing early. Could i pick it up around 3.15 on the way to dover??


I won't be about then :crap: but I will leave it for you under the front of my 5 matey just behind the passenger side wheel:D.

[Tom@SimplyAutomotive]

Your a star James!! :yeah:

[James5]

Your a star James!! :yeah:

Your welcome matey, when I put these on my cars, I normally put a thin layer of sealant between each layer aswell, but not on the top one where the carb sits but between the others and the inlet manifold surface.

See my 2 sec dogey MS paint drawing attached.


It will be in a brown envelope matey. Have a good weekend matey

[Tom@SimplyAutomotive]

Ok thanks, do i need to replace the thin gaskets??