In car boost controller

[mikey_r5gtt]

I have an in car boost controller but its not connected. Can anyone tell me what I am looking for/what I need IOT get it working again?

It's a manual adjuster, the actuator has a second port on it and I have located the tube that I'm sure goes onto it and that's as far as i've got.

I've seen the diag. in the files section that shows an under bonnet bleed valve that connect to the actuator and carb. But if anyone could shed anymore light that would be great.

Cheers

[Kris M]

Get rid of it mate, they are more trouble than they are worth. The carb will never fuel correctly between two boost limits, Set your boost at the actuator then get the fueling to match :agree:

[mikey_r5gtt]

Fair one mate, It's going in to get the fueling set up next week but as its already fitted I thought I could make use of it. Was sort of pressure could I run without doing damage? Ive got a T25 and FMIC?

[Chris Hebden]

I'm thinking of plumbing mine back in, it used to be set up to run 12-22 psi and the fuelling was all over the place! Now I have un-blumbed it I have gone straight from the middle of the carb to the actuator and i am struggling to hold 16psi so i'm thinking of using the in car as a bleed valve!