Help needed please

[Arron V R5GTT]

Hi just got an in car boost controler but im not sure how to pipe it up it has 3 ports one blocked off and two free does any one know where to plumb up to im running the cup mod at the minute thanks in advance:)

[RAGOONEY]

Hi just got an in car boost controler but im not sure how to pipe it up it has 3 ports one blocked off and two free does any one know where to plumb up to im running the cup mod at the minute thanks in advance:)

When I used to have an in car boost controller I ran it with an under bonnet bleed valve between the actuator and bottom of carb also, to set max boost. The 3 ports - leave one open to air, block one, and route the last one to the bottom of the under bonnet bleed valve. You may want to run tubing from the venting port on the in car controller through the bulkhead into the engine bay. :)